codelegend.com

Hi Steve

just trying out preview 16

when i search for a flight with EGGP as departure and flight generator set for 2.5 hours i am only getting 1 airport not sure if i am not doing something right ifr direct

Thanks

I made a new profile and changed to EGGP, then in the flight generator page I set the max duration to 2:30, the min duration I left on 1:45

I get around 70 airports with the Mooney set with Length Width zero feet. That accepts runways of any length.

I set an unfeasible 10,000 feet runway length and get only nine airports.

I then set the filter for only include airports with parking codes and got seven.

I then set the min duration to 2:45. When I pressed the search it reset to 2:15.
In the 15 minute doughnut area that describes I get four listed, including my departure.

Seems good.

Have a look at the plane, the parameters page. Also take a look at the filter.

...thanks a lot for trying it out Garry.

Thanks Steve
dont know what i did wrong but copied your setup and it is working now

Many thanks

Garry

That's good.

Well, you probably did nothing wrong. Some options can leave you with no airports depending on where you are departing.

Stretch the search by reducing the min time and increasing the max time.