codelegend.com

Steve, I started a flight, pushed back and then ended the flight with out saving the new location. The 'browse airport' page worked fine.

Brent

That means it must have to add your score. Forgot about the move to new location. Can you move a few yards and exit the flight and save the new location?

I just landed and parked up. Accepted the tick and before doing anything else, with code in place to capture the error I went to the browse map page and...no error so far.

Brent, by the way I presume you are using IF10 original? [sm]

Hi Steve - I started a flight, moved a bit and then ended the flight. IF reminded me I was in a flight, accepted and saved new location (check mark). IF gave me this 'Flight Prep' page: I can't remember if there's something amiss there (no flight plan details!)



This time I received the out of bounds error message when I went to the browse airport page.

I am using IF10 original [sm].

Thanks
Brent

When we accept a new parking location we have to build a new flight after that so the old flight is gone, that's fine.

But we are getting warmer perhaps? You only need to accept a new location, and before doing anything else go to the map page, the map page does not appear as it stays on the main page but the controls go blank?

When I accept the new location, IF takes me to the main page as shown above. When I select the browse airport page, IF blanks out on me and gives me the error message.

That narrows it down a lot since it doesn't involve updating the score.

So long as you have been to the Flight Gen page first the map page will go in?

That's correct....but only if I generate a new flight or perform a search of possible destinations.

Thanks Brent, that should be enough to go on...

Brent,

This should be a simple bug to find but it's turned out hard to replicate and I've not found the cause of the problem.

Wondering what we can try to see if it changes the outcome - can you try a new profile to see if that has the same issue?
Steve