codelegend.com

Is it possible to add more than 11 airports from subset and put a little star or check next to the already visit airports? When it drops down you can see every airport visited. Thanks.

This is the perfect app for a lazy arm chair pilot like me.

I will see if the visited airport can be shown in the dropdown.

When adding airport iCAOs to a Subset, when the Subset is next loaded into the filter on the flight gen page any repeated occurrences of ICAOs will be deleted. If you add ICAOs with any IF10 functions it will reload the subset. So you can add as many airports to a subset and not worry if they already appear in the list.

" put a little star next to the already visit airports? "
done

Thanks Steve..

Please try preview 21 available in newbuilds - also has Visited/NotVisited filter.

Will do..How is v4 coming along. Hoping I could fly with it this weekend.

Yes sorry about the delay - I was hoping too but run out of time - will try to release before next week end.

Whooooo!!!! Like the little stars. Now I no where I been and where I need to fly to. No more writing down airport codes.No more paper. Thanks Steve you the man!!!

When visited airports are mark checked what does that do?

If you check the Visited box only those airports you already visited show up in the list. Remember that no matter what checkboxes are used the filter always allows added to the list the current airport you are at and if a flight is ready the destination is also added to the list irrespective of the filter settings.