A2A T6 and IF10

[Steve Waite]

Turns out it's a problem with the T6 which is stuck in an exception loop and is altered by any other activity FSX makes with a SimConnect client. It's there with or without IF10 and can be seen clearly in the SimConnect log.

[Brent]

Hey, good job Steve!
Is this something A2A can change or is it baked into their aircraft in order for it to operate correctly. Can you reach out to them and explain the issue for their consideration?

Cheers
Brent

[Steve Waite]

Yes should be fixable they do their own code. I only tried it with the latest version updates. It's quite clear in the simconnect log. It works OK in about half the starts on my setup. Seems to be a time out or similar and simconnect problem can be seen with or without IF10. Any other simconnect client just alters the outcome seems random.

[Steve Waite]

...So far I've not found any way to contact them.

[Steve Waite]

I'll be trying it out in P3D shortly...

[Steve Waite]

Unfortunately seems worse in P3D, didn't get it to work even once other than a half turn when reloading the plane. That's in a stock P3D v3.3.5.17625 no other addons scenery or planes, no other dlls or panel exes. Trying from IF10, since IF10 takes the default views from the aircraft there's a blank panel in the 2D view. I could close to get rid of the blank panel, but the Hand Prop refused to work just the same.

If there was something I could do to get it going in IF10 I would have done so by now. Will have to wait for A2A.

[Brent]

Just a thought...did you run the latest A2A update?

[Steve Waite]

Yes, I only tried with the latest updates, FSX and P3D versions.

[Brent]

Were you able to contact them directly or on their forum?

[Steve Waite]

I've not gone onto the forum and they don't have a contact email.