problem arrive depart

[zoran]

Im trying to fly from PAJN -PANC

Pajn loads correctly and Panc loads ok except IF throws out PAJN and substitutes it with KBNA (random?)

I have all airports ticked. Also its taking twice as long to load the flight and always flips back to KBNA. perhaps some one can try it and see what happens

[Steve Waite]

Seems to work fine with a Beechcraft Baron 58 loaded.
Can your aircraft reach altitude?

[Steve Waite]

have you got a change in the scenery?
can you go back to the start page and run the index...

[zoran]

jeneau INT.

mislead you a bit, Pajn doesnt load neither does the name jeneau INT. the codes load in fsx okay

Im getting a list of browsed airports instead.

just today reinstalled IF. indexes okay

[Steve Waite]

can you load a default aircraft like the baron and try it?
are theses airports addon airports?

[zoran]

yeah Panc is an add on .

A final summary. ignore previous posts

with baron ,Both airports detected and they show on the left side of the screen. PAJN loads okay BUT PANC is hesitant to load and then changes to a random airport.

message" a flight could not be loaded pls adjust parameters and try again

[Steve Waite]

i'll load it up and have a look at it. back later..

[Steve Waite]

..the map of addon PANC is empty
Built a flight OK, obviously some problems there, could be affecting the flight building too.
I'll sort out the map and have a look for any other problems.
Back later. Thanks for helping!